Equipment of the Spraymat^® S700:

1. Base / Base addition

- Needle valve for each nozzle to adjust air spray.

- Needle valve for each nozzle to adjust quantity of liquid.

- Ascending pipe for liquid with non-return valve and liquid filter.

- Pressure reducing valve for spray air to adjust spray jet (low pressure = coarse spray droplets; high pressure = fine spray droplets).

- Manometer (0 – 10 bar) on pressure reducing valve to indicate spray air pressure.

- Push-in connection for compressed air supply Ø6.

2. Reservoirs 1.0 to 40 litres available:

- Reservoir 1.0 litre PE (S700/1 only) with aluminium screw cap, ventilation plug and wall bracket (can be supplied with 2 x round magnets Ø57, on request).

- Reservoir 6.0 / 20 or 40 litre PP, with filler neck, screw plug, detachable sieve, automatic ventilation, hinged cover, visual fill level display on the outside. Can be supplied with float switch min or min+max (potential-free, either NC or NO). Wall bracket for reservoir 6.0 litre on request, with or without 4 round magnets Ø57.

 Details: reservoir 1.0-litre

 Details: reservoir 6.0-litre

3. Drive electric, pneumatic or manual option:

- Solenoid valve 3/2 way (up to 4 nozzles 120 Nl/min, over 4 nozzles 1300 NL/min) with auxiliary actuation (for occasional manual switching on/off). Coil with plug in 24VDC, 24VAC, 110VAC or 230VAC. In case of separate actuation each nozzle (group) controlled via a dedicated solenoid valve.

- Pneumatic valve 3/2 way (up to 4 nozzles 550 Nl/min, over 1300 NL/min)

- Hand actuated ball valve (2/2 way).

4. Feed tube 

- Coaxial feed tubes, PUN Ø8 outer with internal PUN Ø3. Standard length: 1,000; non-standard length: see Technical Data. On request with outer metal protection sleeve.

5. Nozzle:

- Venturi nozzle VD07 for lower capacity of up to 1l/h. Available in copper tube or multi link tube style, length 300. Nozzle tip full jet as standard or flat-jet. Different mounting options available.

-  Venturi nozzle VD15 for higher capacity of up to 6l/h. Available in copper tube or multi link tube style, length 300. Nozzle tip full jet. Different mounting options available.

6. Option

-  Pneumatic drip shut-off system (per nozzle) in FPM. Required if the nozzle is inserted underneath (otherwise danger of subsequent dripping) or far above (otherwise increased reaction time) of the reservoir level.

-   Filler reservoir 2.0-litre to fit into the filler neck of the 6.0 / 20 or 40 reservoirs. This solution enables you to fill in media of higher viscosity faster through the sieve. So the operator does not have to wait until the media is poured in. (Note: To prevent a flow over, the filler reservoir most not be filled with a bigger volume as the reservoir can take in.)

 Details: Nozzle types

  Details: Nozzle tips